BlogHotel.orgAccueil | Créer un blog | Imprimer la page Imprimer | Blog hasard Au hasard | Chercher des blogs Rechercher | Entrer dans le chat du blog Chat | | Jeux Jeux | Adminitration et édition du Blog Manager



It is important to make sure that the vellum does not extend
You will be able to see this because the embossing powder will stick to the design that you stamped with the Versamark inkpad. Run your string through these holes and tie around your votive holder! And, VOILE! A One-of-Kind Votive Shade that was fun and inexpensive to make! You can find more candle decorating ideas at www. Turn the vellum upright and make sure all stray powder has been shaken or tapped off.5. It is important to make sure that the vellum does not extend past the top of the votive holder because this will increase the risk of a fire hazard. But be careful because the heat tool can get VERY hot! You will now have a beautiful raised design of the stamp you chose! Let cool for 1-2 minutes. Now you can just color inside of the design on the opposite side of the vellum.Embossed Votive Holder Shadeby: Michelle GauthierEmbossed Votive Holder ShadeCreate the look of a Stained Glass Votive HolderSupplies Needed:Most items can be found in the Scrap booking/Stamping section of your local craft store.com. Finally, use your hole punch to make holes in the center of the shortest sides of the vellum. Now sprinkle the embossing powder onto the stamped design.4. Use your Embossing Heat Tool to heat the powder. Darker Colors look better for this as they give a bolder appearance when the candle is lit.ExpressiveCandles. After you have planned your design with your stamp(s), use the Versamark ink to stamp the design onto the vellum.6. Use these measurements to cut out a piece of vellum. Measure the height and circumference of your Glass votive holder with a tape measure or ruler. At this point the design will be clear. Allow to dry for aproximately 5 minutes or the colors may smear.3.2.Straight-Sided Clear Glass Votive HolderVellumCraft Markers of various colorsHole PunchDecorative StringEmbossing Powder in your choice of colorVersamark Ink PadEmbossing Heat ToolScissorsTape Measure or Ruler1. Also make sure that your entire design has been covered in powder
Posté le 15/10/2020 - 04:06 -
{ Commentaire 0 } Posté un Commentaire